BN Products BNG2000 Manual del operador descargar pdf (Pagina 13)

Page | 13

6.4 - VALVE CLEARANCE

After the ﬁrst 50 hours of operation, check the valve

clearance in the engine and adjust if necessary.

Important: If you are not comfortable with this proce-

dure or the proper tools are not available, please take

the generator to the nearest service center to have the

valve clearance adjusted. This is a very important step

to ensure longest life for the engine.

6.5 - GENERAL

The generator should be started at least once every

seven days and be allowed to run at least 30 minutes.

If this cannot be done and the unit must be stored for

more than 30 days, use the following information as a

guide to prepare it for storage.

DANGER - NEVER store engine with fuel in tank in-

doors or in enclosed, poorly ventilated areas where

fumes may reach an open ﬂame, spark or pilot light as

on a furnace, water heater, clothes dryer or other gas

appliance.

CAUTION - Avoid spray from spark plug holes when

cranking engine.

DANGER - Drain fuel into approved container out-

doors, away from open ﬂame. Be sure engine is cool.

Do not smoke.

DANGER - NEVER cover the generator while engine

and exhaust area are warm.

SECTION 7 - STORAGE

It is important to prevent gum deposits from forming in

essential fuel system parts such as the carburetor, fuel

hose or tank during storage. Also, experience indicates

that alcohol-blended fuels (called gasohol, ethanol or

methanol) can attract moisture, which leads to separa-

tion and formation of acids during storage. Acidic gas

can damage the fuel system of an engine while in stor-

age.

To avoid engine problems, the fuel system should be

emptied before storage of 30 days or longer, as follows:

Remove all gasoline from the fuel tank.

• Start and run engine until engine stops from lack

of fuel.

• While engine is still warm, drain oil from crank-

case. Reﬁll with recommended grade.

• Remove spark plugs and pour about 1/2 ounce (15

ml) of engine oil in the cylinders. Cover spark plug

hole with rag. Pull the recoil starter a couple times

to lubricate the piston rings and cylinder bore.

Install and tighten spark plugs. Do not connect

spark plug wires.

• Clean the generator outer surfaces. Check that

cooling air slots and openings on generator are

open and unobstructed.

• Store the unit in clean, dry place.

• Do not store gasoline from one season to another.

1 2 ... 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios

BN Products BNG2000 Manual del operador Pagina 13

Comentarios a estos manuales